Small modules CHNSW-215W-225-235-M

Small modules CHNSW-215W-225-235-M

They are applicable to distributed projects. Maxim integrated power chips make MPPT (maximun power point tracing).Maxim can contribute to lower generating cost and generating capacity increase by 30%.The good impedance matching function effectively improves the mismatch problem and maximizes the power output.Maxim can eliminate the hot spot effect of the module and reduce the loss of the module.The safety performance is good.

EFFICIENCY

1.Low voltage-temperature coefficient allows higher Power output at high-temperature condition
2.High efficient, high reliable solar cells ensure our Product meets output stability.

MATERIALS

1.Advanced EVA encapsulation system with Triple-layer back sheet meets the most stringent safety requirements for high-voltage Operation. 

2.The sturdy, anodized aluminum frame allows The modules to be mounted on a variety of standard Racking systems to withstand harshest of European conditions

3.Ultra reliable bypass diodes prevent damage through Overheating due to shaded or defective cells.

4.Innovative, environmentally friendly packing method Using pile-edges insures modules arrive in perfect Condition.

5.New frame design incorporating Drainage holes, with more grounding holes, provide Flexible installation and use

BENEFITS

1.Manufactured IEC61215, IEC61730, ISO 9001:2008 MCS, TUV, CE
2.High efficiency, high safety, high reliability
3.Output power tolerance of -3%-+3 %
4.10 years Fully Backed CHN Insurance Product Warranty.
5.Standard 25-years Limited warranty on Power output, 3-years Product Warranty. Limited warranty on materials
and workmanship
6.Container load: 600pcs on 28 pallets in 40’ container and 240 pcs on 12 pallets in 20’ container.

NOTE

This publication summarizes product warranty and specifications, which are subject to change without notice, additional information may be found on our web site: www.htwindsolarpower.com

Module Characteristics 

Note: the specifications are obtained under the Standard Test Conditions (STC):1000W/ m² solar irradiance, 1.5 Air Mass, and cell temperature of 25Degrees C

• CHNSW-215W-225-235-M Download